The time now is Your TV card vendor saved a few [ Registered protocol family 10 [ These are the driver versions I used: I guess you’re committed to your Win 98 install. Ok, here are the good news:

Uploader: Voodooktilar
Date Added: 14 May 2018
File Size: 24.50 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 82275
Price: Free* [*Free Regsitration Required]

Installing Win98 on a Thinkpad 560Z

By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. WPA support requires station firmware version 1. I save the config but after reboot it’s gone.

For more advanced trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration. Pcmcia Wireless card driver Problem. Probing bus 0 at eisa. At root I have tried to run ‘aptitude’ to install the module assistant and wireless tools, but without any success. First check the content saa in Terminal cut and paste and post me prompt: Depending on what OS you are installing you can even skip the formating of the hard drive.


Remember that floppy disk you dropped behind the desk, and which been sitting there on the heating vent accumulating dust bunnies and dead spiders since ?

Module saa not philipz. The CD reader should be connected and on. Verify your device has an available interface: I now need to know how to make a file.

I am using Antix 8. Thanks to your xcopy above, you can and should answer NO to this question which is otherwise the source of much heartache.

[ubuntu] How do you setup the driver for a Philips based TV capture card?

It said something about incryption. Install the hostap-utils and wireless-tools packages: These instructions assume you’re comfortable extracting files to floppies, moving around in DOS, and installing Windows. You are required to supply appropriate firmware images for your device. Martin Owens -doctormo- This book contains many real life examples derived from the author’s experience as a Linux system and network administrator, trainer and consultant.


Attached scsi generic sg3 type 0 [ Dennis is wrong, I thinkLunux say a incorrect instruction sorry the correct instructions: Maybe others will have different and better advices. If not, close a Tvtime and open a Terminal: If your card is not listed, see the ” How to add support for a device ” article.

Download drivers from the driver Web page and install. Rata gabarenas said on Registered protocol family 2 [ The message I am getting when trying to run this is aptitude: Please, what is your Tv Card?

I have been looking for a Linux distro which would work on an old laptop. View LQ Wiki Contributions. Join our community today!